Abrading Methods Lapping

Lapping Company

Lapping Home
What Is Lapping
Lapping Company
About Lapping

Lapping Services
Lapping Flat Honing
Lapping Fine Grinding
Lapping Samples

Lapping Links
Lapping contact
Report Spam

Flat Lapping Experts

Stainless Steel Disk Hubs
Lapping

The Challenge:
To lap or flat hone very small and extremely hard materials like Sintered Alnico 5, Alnico 8,Carbide and high Alumina Ceramics

Part Specifications

Material: 17-4 PH Stainless Steel
Previous Operation: Metal injection molding & Sintering
Dimensions: 31mm OD x 2.94mm Thick

Pre-machined Condition

Thickness: 3.45.05mm [3.40mm / 3.50mm]
Surface Finish: 6 Ra
Flatness: 0.1mm
Parallelism: 0.05mm
Presentation: This part was Molded, Sintered , Lapped and de-burred

Results:

Thickness: .2.96mm 0.1mm
Surface Finish: No requirement
Flatness: .05mm
Parallelism: .05mm
Notes: Burr free requirement and a minimum
CPk of 1.33
 

lapping.com and the editorial content, graphics, and products of the lapping.com website, unless otherwise noted, are the products of Abrading Methods, Inc. The information presented on lapping.com is copyrighted as collective work. Any unauthorized reproduction, by any means, mechanical or electronic, without the express written permission of Abrading Methods, Inc is strictly prohibited.

Copyright 2007. Abrading Methods, Inc.
All Rights Reserved